I/O Controllers - Network I/O interfaces
The I/O Controllers allow remote control of digital inputs, outputs and a RS232/485 serial port over Ethernet.
Two boxes can be connected to each other thus prolonging the inputs, outputs and serial line over Ethernet (box-to-box mode).

ATC-277SM Fiber to serial Converter
The ATC-277SM is a Single Mode Optical Fiber Modem, that allow the connection of RS232/422/485 devices over a single-mode fiber cable.
The device allows connection over up to 20Km of fiber cable and supports point to point or ring (point to multipoint) networking.
The converter can also be used as "Repeater" to create a multi-drop master/slave configuration, allowing one serial device to talk to multiple slave devices around a fiber ring.

N-Male to N-Male LMR-400 Coaxial cable
Ultra low losses coaxial cable provided of N-Male connectors at both ends. Made with LMR-400 ultra low losses coaxial cable it allows to connect RF equipment with external antenna.

Wi Fly Wireless LAN Module
The WiFly GSX module is a stand alone, embedded wireless 802.11 networking module. Because of its small form factor and extremely low power consumption, the device is perfect for mobile wireless applications such as asset monitoring, GPS tracking and battery sensors.
The WiFly GSX module incorporates a 2.4GHz radio, processor, TCP/IP stack, real-time clock, crypto accelerator, power management and analog sensor interfaces.

PicoStation AP 2,4/5GHz
The PicoStation is the smallest and powerful AP (Access Point) actually available on the market.
It provides cheaply, reliability, & performance, with its up to 500m of outdoor range and 54Mbps of throughput. PicoStations are provided of the powerful and intuitive AirOS by Ubiquiti.

PicoStations are provided of omnidirectional outdoor antennas and wall/pole mount kit.

DL Series Radiomodems
These apparatus allows a point-to-point (or point-to-multipoint) wireless connection between two or more RS232/485 devices, in completely transparent mode. All devices of this series are provided of one optoisolated digital input and one digital output (relay).

The devices of this series are available in the following frequencies:

• VHF 169.400-169.475Mhz (DL169),
• UHF 433.050-434.790MHz (DL433)
• UHF 868-870Mhz (DL868)

and are all characterized by low cost and free use.

IP Water Leak Detector
HWg-WLD is a network-enabled water leak detector with a water-absorbing sensing cable. HWg-WLD features a built-in web server, SNMP support, and e-mail alert in case of water flooding. It can remotely control a relay output over the network (a relay is switched when a water leak is detected along the sensing cable). HWg-WLD detects water leaks or water floods along the entire length of the sensing cable. The sensing cable detects even the smallest volume of water, ethylene glycol, or other conductive liquid.

Ethernet interface Poseidon series
The Poseidon devices allow monitoring and transmitting of information and critical values over a network. The apparatus of this series support up to 42 sensors that may be located up to 1000 meters from the unit of measurement. The measured values may be accessed through the web or through M2M protocols (SNMP, XML, Modbus/TCP etc.) and monitoring software.

Ethernet interface Damocles series
The Damocles family devices allow the I/Os management over ethernet network. Are supported the most common network protocols (SNMP, Modbus/TCP, XML etc.). Damocles models differ each other by numbers of inputs and outputs on the unit.

NanoBracket - Holder for NanoStation
Nanobracket is an holder for NanoStation, NanoStation M and NanoStation Loco. Nanobracket is made from plastic which results into its lightness and easy manipulation. Mount NanoBracket is compliant with NanoStation in material it is made from and in color as well. Therefore the device and NanoBracket look like one entity after mounting. NanoBracket allows mount NanoStations on wall, mast and console as well.